Details for DDEntity "220 - Last Bale Average Bale Compression Plunger Load"
| 220 - Last Bale Average Bale Compression Plunger Load Request changes |
|---|
| Definition | The average bale compression plunger load for the most recently produced bale expressed as percentage. |
|---|---|
| Comment | The recommended use of this DDE is for a baler to report this once for every bale that is produced. A baler may add this to its default set of data, based on an internal on-change data trigger that causes the baler to report the value of this DDE after the bale is produced. The recommendation for data logging is that all "Last Bale" DDEs that are supported by a device are reported together at the moment that the bale is produced and leaves the machine. |
| Typically used by Device Class(es) |
7 -
Harvesters 9 - Forage harvester |
|---|
| Unit Symbol | ppm - |
|---|---|
| Bit Resolution | 1 |
| SAE SPN | |
| CANBus Range | 0 to 2147483647 |
| Display Range | 0 to 2147483647 |
| Submit Date | 2011-04-30 |
| Submit By | Jaap van Bergeijk |
| Submit Company | AGCO |
| Revision Number | 1 |
| Current Status | ISO-Approved |
| Status Date | 2011-04-30 |
| Status Comments |
|
|
|
|
2011-04-30: ISO-Approved
|