Details for DDEntity "263 - Average Yield Mass Per Area"
| 263 - Average Yield Mass Per Area Request changes |
|---|
| Definition | Average Yield expressed as mass per unit area, not corrected for the reference moisture percentage DDI 184. This value is the average for a Task and may be reported as a total. |
|---|---|
| Comment | This Average Yield Mass Per Area is the mass that includes the average crop moisture (DDI 262) if this is measured on e.g. harvesting equipment. This average yield mass per area is calculated as the yield total mass (DDI 90) divided by the total area (DDI 116) of the active task. When a task is resumed and its previously recorded totals are sent by the task controller to the connected working set, a situation can occur where there is a discrepancy between the yield total mass, the total area and the average yield mass per area values. In case all three of these DDI's are present in the device description and all three values are set by the task controller upon resuming a task, the working set shall compute its average yield mass per area from the yield total mass divided by the total area and shall discard the average yield mass per area value that it received from the task controller. |
| Typically used by Device Class(es) |
7 -
Harvesters 8 - Root Harvester 9 - Forage harvester 14 - Special Crops |
|---|
| Unit Symbol | mg/m² - |
|---|---|
| Bit Resolution | 1 |
| SAE SPN | |
| CANBus Range | 0 to 2147483647 |
| Display Range | 0 to 2147483647 |
| Submit Date | 2011-07-08 |
| Submit By | Robert Waggoner |
| Submit Company | AGCO |
| Revision Number | 2 |
| Current Status | ISO-Published |
| Status Date | 2011-10-17 |
| Status Comments |
|
|
|
|
2011-10-17: ISO-Published
2011-10-17: ISO-Submitted (Pending)
2011-07-11: Request Pending
|