Details for DDEntity "287 - Setpoint Prescription Mode"

287 - Setpoint Prescription Mode Request changes
DefinitionThis DDE defines the source of the Task Controller set point value sent to the Control Function. This DDI shall be defined as DPD in the DDOP and needs to be setable. The TC shall then set this DDI before starting a prescription operation. The WS (Working Set) shall set this value to zero (0) after system start.
CommentThe Task Controller Prescription Mode shall have the following values: 0 = Unknown / not defined 1 = Prescription Rate 2 = Prescription Default 3 = Prescription GPS loss 4 = Prescription Out Of Field 5 = Manual Entry 6 = Peer Control 7 and higher are reserved for future assignments
Typically used by Device Class(es) 4 - Planters /Seeders
5 - Fertilizer
6 - Sprayers
Unit Symboln.a. - not applicable
Bit Resolution1
SAE SPN
CANBus Range0 to 6
Display Range0 to 6
Submit Date2013-09-23
Submit ByJoe Tevis
Submit CompanyTopcon
Revision Number2
Current StatusPublished
Status Date2022-10-28
Status CommentsChange status to published
Prescription Mode Supporting Doc-v1.ppt
1,021.00 KB Upload: 2013-09-23 02:15:02
Prescription Mode and Control Function Mode Use Cases
2022-10-28: Published Change status to published
2015-07-30: ISO-Submitted (Pending)
2013-09-23: Request Pending

Back