Details for DDEntity "219 - Actual Bale Compression Plunger Load"

219 - Actual Bale Compression Plunger Load Request changes
DefinitionThe actual bale compression plunger load expressed as percentage.
CommentThis is the plunger load measured at the rear dead end of the plunger cycle and only updated for each new flake that has entered the baler chamber.
Typically used by Device Class(es) 7 - Harvesters
9 - Forage harvester
Unit Symbolppm -
Bit Resolution1
SAE SPN
CANBus Range0 to 2147483647
Display Range0 to 2147483647
Submit Date2011-04-30
Submit ByJaap van Bergeijk
Submit CompanyAGCO
Revision Number2
Current StatusPublished
Status Date2018-02-26
Status CommentsThere was an industry request to change the unit to ppm.
2018-02-26: Published There was an industry request to change the unit to ppm.
2016-03-11: Request Pending There is no sense in a load value with no base unit. We used it like 1%/bit, that's why we advice to use this resolution. Please check with other manufactures and make this one fix. ppm might make more sense to be future proof, but if all manufa
2011-04-30: ISO-Approved

Back