SPN5140
SP NameStop all implement operations
SP DescriptionState of a switch or other operator input to immediately stop operation of all functions that were activated by operator controls or message commands from a VT, auxiliary control input, TECU, task controller or sequence control master. This switch shall be available to the operator at all times. When the activation of this switch has caused all implement operations to stop, a “permit all implement operations state” does not directly restart an implement. Implement operations shall only be restarted by the use of a start/stop (“Master ON/OFF”) switch or other such means.

This operator input is independent of any other type of input and is located in each operator location that can be used during implement operations. This input shall meet the requirements of ISO 15077 for its location and operation by an operator to activate stop implement operations.

The implement shall not rely solely on this stop all implement operations operator input to stop the implement. An implement shall provide another means by which to stop normal implement operation such as a dedicated start/stop switch, a soft key or button on a VT or an auxiliary input assigned to the operations stop function.

Value Meaning
00 Stop implement operations
01 Permit all implements to operation ON
10 Error indication
11 Not available
Sp NotesNot set
Has Attachmentno
SP Historical Remarks-
SP Historical Attachmentno
From 2015/20192015
SP Length2 bits
Scaling4 states/2 bit
Offset0
Data Range0 to 3
Operational RangeNot set
Unitsbit
Slot Identifier87
Slot NameSAEbs02
SP TypeMeasured
SP ReferenceNot set
Scale Factor (value only)1
Offset (value only)0
Range maximum (value only)3
Length minimum (value only)2
Length maximum (value only)2
SP DocumentISO 11783-7
PG Created or Modified Date2008-05-23
PG SP Mapping Created/Mod. Date2008-05-23

Linked PGNs

Displaying 1-1 of 1 result.
PGNPG Label 
64770All implements stop operations switch stateView